SEN0161-V2

SEN0161-V2 is a lab-grade analogue pH sensor kit for Arduino / Raspberry Pi (with calibration solutions). The analogue pH meter V2 is specifically designed to measure the pH of the solution and reflect the acidity or alkalinity. The DFRobot pH sensor is commonly used in various applications such as aquaponics, aquaculture, and environmental water testing. The sensor can be easily connected to most popular microcontrollers (such as Arduino), with its Arduino library, you can quickly build a pH meter, plug and play. DFRobot provides a variety of water quality pH analogue sensor products, uniform size, and interface, not only meeting the needs of various water quality measuring but are also suitable for the DIY multi-parameter water quality tester.

• 3.3~5.5V wide voltage input
• Hardware filtered output signal, low jitter
• Gravity connector and BNC connector, plug and play, no welding
• Software library supports 2-point calibration and automatically identifies standard buffer solution
• Uniform size and connector, convenient for the design of mechanical structures
• BNC probe connector
• Temperature range from 5~60°C
• Probe life: >0.5 years (depending on the frequency of use)
• Cable length is 100cm

內容

PH probe (laboratory grade) x 1, pH signal conversion board x1, Gravity analogue sensor cable x 1, pH standard buffer solution 4.0 x2, pH standard buffer solution 7.0 x 2, Waterproof gasket x 2, Screw cap for BNC connector x 1, M3 x 10 nylon pillar x 4, M3 x 5 screws x 8.